The CCIE Service Provider lab exam is considered to be an eight-hour hands-on exam, which the candidates have required a candidate to configure, optimize, diagnose, as well as troubleshooting a series of complex network scenarios for a given specification which would be based on dual stack solutions (IPv4 and IPv6). Knowledge of troubleshooting is considered to be an important skill and candidates would be expected to diagnose and solve issues which are considered as part of the CCIE lab exam. The candidate would not configure about all end-user system, however, the candidate is considered to be responsible for all devices residing in the network. This certification exam will need a good practice, which you could gain through expertise training, which would be gained through the SPOTO.
The format of the CCIE Service Provider Lab Exam:
The eight-hour CCIE Service Provider Lab Exam consists of three modules and I would need to be taken in the following sequence during the day of the exam:
Module 1: Troubleshooting module:
The Troubleshooting module is going to deliver the incidents that would be independent of each other, which means that the resolution of one incident which wouldn’t be depending on the resolution of another. The topology that would be used in the Troubleshooting module is quite different than the topology which is used in the Configuration module.
Module 2: Diagnostic module:
The Diagnostic module is going to be focused on the skills which are required to properly diagnose network issues, without having device access. Candidates wouldn’t be provided with a set of documentation that is going to represents a snapshot of a realistic situation at a point in time in a process of investigation that a network engineer might have to face. The main objective of the Diagnostic module is to assess the skills which are required to diagnose properly the network issues.
Module 3: Configuration module
The Configuration module is going to provide the candidate’s setups which are very close to an actual production network. At the beginning of this module, the candidates are required to have full visibility of the entire module. A candidate would choose to work in the sequence in which the items are going to be presented or could resolve the items in whatever order it seems logical and preferable.
The Annual salaries are considered as high as $211,000 and as low as $84,500, the majority of CCIE Service Provider salaries currently range around $125,500 to $174,500. The average pay range for a CCIE Service Provider would be varying little about $49,000, which suggests that regardless of location, there aren’t many opportunities for increased advancement or pay, even with several years of experience.
For the CCIE Service Provider Lab, both the troubleshooting and the configuration module are organized in a 100% virtualized environment. The web-based delivers the infrastructure in order to support this virtual environment, using the VIRL/CML.
The diagnostic module, however, could be based on real equipment like the Cisco ASR9000 Series and the Cisco Metro Ethernet ME 3600x Series. If you want you could refer to the equipment and software list which are provided on the Cisco Learning Network.
Topologies which were going to be used within all the three modules which are represented realistic service provider between modules and backbone scenarios. The main focus of the lab exam would be to test and validate troubleshooting, configurations, and diagnosing skills, rather than evaluating specific platform and/or knowledge of software.
There are lots of other CCIE Service Provider Lab Topologies, and if you want to gain it all you should have the courses, which are provided by the SPOTO. SPOTO institute provides you with the best study dumps and lab practices, which they provide with the passing guarantee. So, if you want to clear this certification in a single attempt, you should gain their training courses provided by SPOTO.